If you have vinyl or metal flanged windows for instance you can install drip cap flashing 4 the home depot over the window itself or over the top trim piece that you install.
Install z flashing siding.
The siding comes in 4 foot by 8 foot panels that install vertically.
The type and location of the flashings will vary depending on the type of windows and doors.
If the kick out and step flashing can t tuck behind the siding screw on cap flashing to cover it then caulk along the top.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
Item 3807 model 5504900120.
The seat dimension 3 8 in corresponds to the siding thickness.
Nail it to the sidewall or glue it if nailing isn t possible.
Lift the bottom shingle and slip in the kickout flashing.
It is used to protect the horizontal joints between sheets of siding from water infiltration.
Pry the siding out near a nail then push the pry bar against the nail as you partially tap the siding back in.
T1 11 siding provides a paneled look for sheds barns and some houses.
Slip the back flashing under the siding at least 3 at the top and the sides.
Cover with cap flashing.
The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.
Place the z flashing into position on top of the casing.
For a wood window unit drip cap flashing can be installed over the trim piece often called brick molding that comes.
That should pop the nail head out far enough so you can pry it out.
You may need to pry out siding first.
Install the kickout flashing.
When installing the flashing the longer edge goes against the wall of the house the center section rests on top of the casing and the.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
This will ensure that any fasteners that go through the trim or the siding will penetrate the self sealing membrane of the tape.
If nails are in the way pull them out.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall.
How to install z flashing on rotted t1 11 siding.
Install the first length of z flashing.
When choosing a flashing tape be sure to choose one that s 2 to 3 inches wider than the window trim.
