Plastic injection molding tab gate design 3.
Injection mold fan gate design.
It permits rapid filling of large parts or fragile section mold area with large entry area.
It is used for the plastic part of a large area.
If unavoidable the weld marks should be designed on the unimportant surface and non weak parts of.
6 2 the edge or fan gate an edge gate is primarily used for molding parts with large surfaces and thin walls.
2 the gate size is dependent on product weight material and gate types.
It has the following advantages.
Used like the disk gate.
Used in large size molded product.
1 injection molding gate is a small opening between the runners and the mold cavity.
If the injection molding requirements meet the smaller the number of gates are the better it is it would reduce the weld marks.
This is only possible how ever for certain materials such as thermoplastic elastomers.
Since the curved core is subjected to the injection force the core is pushed to the opposite side so that the pipe cannot be molding.
It is used to create uniform flow into wide parts purpose 1.
Design fan gate is similar to the side gate but width of gate is bigger and has fan shaped.
Gate is a passage way from the subrunner to the mold cavity and its cross section is the smallest and shortest part in the injection system.
An edge gate located below the parting line or molded surface.
Thereby keeping the cross sectional area constant.
You can read all the content.
Normally used with thin wall parts.
But the test results show that.
The runner and gate system used in plastic injection molding is responsible for directing molten plastic from the nozzle of the molding machine into the cavity of the tool.
In fact the fan gate is an extended design of the side gate.
Used in large size molded product.
Its structure is similar to the side gate but gate width is bigger and fan shaped.
It is used to create uniform flow into wide parts.
Plastic injection molding fan gate design.
Molded part in the mold which is now loaded in the center.
Plastic injection molding fan gate design 4.
Figure 6 2 curved sprue 6 3.
Ring part must get filled first and then the cylinder part otherwise the weld will occur.
The purpose is to make the gate position of the mold consistent with the center of the mold to avoid the gate offset of the mold.
Position number shape and size of the gate have a direct impact on the quality and the appearance of the product and therefore in the design process attention is required for gate style.
Normally used with multi cavity two plate molds.
Fan gate is a gate spreading toward in to cavity basically this gate is thin similarly with previous gate and is used in same purpose with film gate.
Their location quantity shape and size etc.
With the gate construction it permits rapid filling of large parts or fragile section mold area with large entry area.
Have a great influence on product appearance dimensional physical characteristics and production efficiency.
